Felicity Solar IVPS10048P2G1 8000W Inverter / Charger

A 48V inverter/charger holding 8000W continuous from a 10000VA rating, with split-phase 110/120Vac±5% output on HOT1-N or HOT2-N and 90% peak efficiency.

Rated Output Power (Va): 10000VA
Rated Output Power (W): 8000W

1,750 AEDincl. VAT

In stock

Full Specifications Download datasheet (PDF)

Felicity Solar IVPS10048P2G1 8000W Inverter / Charger features

10000VA rated, 8000W continuous

Rated 10000VA and 8000W continuous from a 48V nominal DC input.

20000VA surge for 5 seconds

Carries a 20000VA surge for 5 seconds and is rated to start electric motors.

80A maximum charge current

Charges at up to 80A, regulated anywhere across 0-80A, with over-charge protection.

Split-phase 110/120Vac±5% output

Delivers split-phase 110/120Vac±5% on HOT1-N or HOT2-N from a 220Vac nominal input.

15ms (typical) transfer time

Transfers in 15ms (typical) and charges from utility anywhere in the 90-280Vac range.

584 x 420 x 195 mm, 67.7 kg gross

Measures 584 x 420 x 195 mm at 67.7 kg gross and operates from 0°C~40°C.

About the Felicity Solar IVPS10048P2G1 8000W Inverter / Charger

The Felicity Solar IVPS10048P2G1 is a 48V off-grid inverter and charger rated 10000VA and 8000W, holding a 20000VA surge for 5 seconds and charging a battery bank at up to 80A. It gives split-phase 110/120Vac±5% between HOT1-N or HOT2-N, regulated to ±5%rms, and transfers between utility and battery in 15ms (typical). Utility charging accepts 90-280Vac, disconnecting at 170±7Vac (UPS) or 90±7Vac (APL) on the low side and 280±7Vac on the high side; output is a pure sine wave and synchronises with input voltage in line mode. Battery settings cover 57.6V boost and 54.4V float on AGM, 58.4V and 55.2V on flooded, and 61.0V maximum on lithium, starting from 46V and shutting down at 43Vdc below 50% load. Peak efficiency is 90%, a 63A overcurrent protector guards the grid side, and the unit does not pass utility through without a battery. It measures 584 x 420 x 195 mm, weighs 67.7 kg gross and runs from 0°C~40°C. We are an authorised Felicity Solar distributor and supply the IVPS10048P2G1 from our own stock; warranty 2 Years.

Specifications last updated 23 July 2026

Felicity Solar IVPS10048P2G1 8000W Inverter / Charger full specifications

Electrical

Battery	0₁
Power	0₁
BMS communication	24V model(default 27.0V) bm5 6 bmS
Capable of Starting Electric	Yes
Efficiency(Line mode)	>95%
Max. Bypass Overload Current	30A AC63A
Nominal Output Frequency(Hz)	50±0.3Hz/60±0.3Hz(adjustable) backlight will go out after 60s.
Output	split-phase system, make sure no "PAL", 3P1, 3P2
Output Frequency	50Hz
Output voltage	25.0V to 31.5V. Increment of
Power derating	216-06 221
Rated Output Power (VA)	10000VA
Rated Output Power (W)	8000W
Nominal DC Input Voltage	48V
Input Voltage Waveform	Sinusoidal (utility or generator)
Terminal Connection	HOT1-HOT2
Nominal Input Voltage	220Vac
Low Line Disconnect	170±7Vac (UPS) / 90±7Vac (APL)
Low Line Re-connect AC Input Range	180±7Vac (UPS) / 100±7Vac (APL)
High Line Disconnect	280±7Vac
High Line Re-connect	270±7Vac
Max AC Input Voltage	280Vrms
Nominal Input Frequency	50Hz/60Hz
Low Line Frequency Disconnect	40±1Hz
Low Line Frequency Re-connect	42±1Hz
High Line Frequency Disconnect	65±1Hz
High Line Frequency Re-connect	63±1Hz
Line Mode Output Waveform	Synchronize with input voltage
Over-Load Protection	Air switch protection
Efficiency (Line mode)	≥95%
Transfer Time (AC to DC)	15ms (typical)
Transfer Time (DC to AC)	15ms (typical) / 30ms (special)
Pass Through Without Battery	No
Overcurrent Protector (grid)	63A
Input Voltage Range (utility charge)	90-280Vac
Max Charge Current	80A
Charge Current Regulation	0-80A
Charger Short Circuit	63A
Over Charge Protection	Yes
Output Voltage Waveform	Pure sine wave
Nominal Output Voltage	220/240Vac±5% (HOT1-HOT2)
Split-Phase Output Voltage	110/120Vac±5% (HOT1-N or HOT2-N)
Nominal Output Frequency (Hz)	50±0.3Hz / 60±0.3Hz (adjustable)
Output Voltage Regulation	±5%rms
Peak Efficiency	90%
Inverter Over-Load Protection (SMPS load)	5s@≥150% load; 10s@105%~150% load
Surge Rating	20000VA for 5 seconds
Capable of Starting Electric Motor	Yes
Output Short Circuit Protection	Yes
Min DC Starting Voltage	46V
Low Battery Alarm	46Vdc (load < 50%) / 44Vdc (load ≥ 50%)
Low Battery Recovery	47Vdc (load < 50%) / 46Vdc (load ≥ 50%)
Low DC Input Shut-down	43Vdc (load < 50%) / 42Vdc (load ≥ 50%)
High DC Input Alarm / Fault	63Vdc±0.4V
High DC Input Recovery	62Vdc±0.4V
Boost Charging Voltage (AGM)	57.6V
Float Charging Voltage (AGM)	54.4V
Boost Charging Voltage (Flooded)	58.4V
Float Charging Voltage (Flooded)	55.2V
Self-Defined Charging Voltage (max)	61.0V
Lithium Charging Voltage (max)	61.0V

Mechanical

Product Dimension	584x420x195mm
Package Dimension	670x470x355mm
Gross Weight	67.7 kg

Environmental

Operating temperature	0°C~40°C
Storage temperature	-15°C~60°C

Frequently Asked Questions

10000VA and 8000W. The IVPS10048P2G1 is rated 10000VA apparent power and 8000W continuous, and carries a 20000VA surge for 5 seconds, which is why it is rated as capable of starting an electric motor. Peak efficiency is 90%.

48V nominal DC, charging at up to 80A and regulated across 0-80A. It starts from 46V, alarms at 46Vdc below 50% load or 44Vdc at 50% load and above, and shuts down at 43Vdc / 42Vdc. Lithium charging tops out at 61.0V; AGM boost is 57.6V and float 54.4V.

584 x 420 x 195 mm and 67.7 kg gross. Packaged it measures 670x470x355mm. The unit operates from 0°C~40°C and is stored between -15°C~60°C.

90-280Vac is the accepted utility charging range, and the input waveform is sinusoidal from utility or generator. Nominal input is 220Vac at 50Hz/60Hz, transfer takes 15ms (typical), a 63A overcurrent protector guards the grid side, and the unit does not pass utility through without a battery connected.

Troubleshooting & error codes

Looking up an error code on this FelicityESS IVPS3524P1G1-LV? Browse the full list of codes for this device, with the cause and recommended fix for each.

View error codes for this device →