Felicity Solar IVCM2012P1G2 2kW Single-Phase Off-Grid Solar Inverter

A single-phase 2 kVA / 2 kW inverter-charger built around a 12 V bank: 0.8 kW of PV inside a 30-90 V MPPT window, 120 A of charge current and 165 A of maximum discharge, in a 6.5 kg wall-mounted body.

Rated Output Power: 2 kW
Max Efficiency: 90 %
Max PV Input Power: 0.8 kW
Battery Voltage Range: 10.5-15.75 V

1,600 AEDincl. VAT

In stock

Full Specifications Download datasheet (PDF)

Felicity Solar IVCM2012P1G2 2kW Single-Phase Off-Grid Solar Inverter features

Rated 2 kVA / 2 kW at 230 V single phase, with 2 kW also held as backup rated output power

0.8 kW of PV input under a 105 V maximum, tracked by one MPPT across a 30-90 V window at 99% efficiency

12 V nominal battery bank worked from 10.5 V to 15.75 V, boosted at 14.1 V, floated at 13.5 V and capped at 15 V

Up to 120 A of charge current from AC or solar, 165 A of maximum discharge current and 15 A maximum inverter/rectifier current

90-280 V AC input at 50/60 Hz on L+N+PE wiring, 90 V low-line disconnect and a 20 ms transfer time

6.5 kg net and 8.2 kg gross, wall-mounted, IP21, intelligent air cooling from -10 to 55 °C, and up to 6 units in parallel

About the Felicity Solar IVCM2012P1G2 2kW Single-Phase Off-Grid Solar Inverter

The Felicity Solar IVCM2012P1G2 is a single-phase inverter-charger rated 2 kVA / 2 kW at 230 V and built around a 12 V battery bank that it works between 10.5 V and 15.75 V. It accepts up to 0.8 kW of PV at a 105 V ceiling and reaches 90% maximum efficiency. Its one MPPT tracker holds a 30-90 V window at 99% efficiency, and charging is set by a 14.1 V boost stage and a 13.5 V float, never above 15 V, at up to 120 A from solar or from AC. The single battery input takes AGM, flooded, Li-Ion or a self-defined profile, and maximum discharge current is 165 A. On the AC side the unit works from 90-280 V at 50/60 Hz on L+N+PE wiring, drops the line below 90 V and transfers in 20 ms, the line-mode output following the input waveform. Over-charge, overload, output short-circuit and over-temperature protection are standard, RS485 and CAN carry BMS traffic, and an LCD and LED panel plus built-in WiFi report status. Warranty 2 Years. We are an authorised Felicity Solar distributor and supply the IVCM2012P1G2 from our own stock.

Specifications last updated 23 July 2026

Felicity Solar IVCM2012P1G2 2kW Single-Phase Off-Grid Solar Inverter full specifications

Electrical

AC Output Voltage	230 V
AC Wiring Mode	L+N+PE
Backup Rated Output Power	2 kW
Battery Inputs	1
Battery Type	AGM, Flooded, Li-Ion, Self-Defined
Battery Voltage Range	10.5-15.75 V
Bulk Charging Voltage	14.1 V
Charge Algorithm	Three-Stage: Boost CC, Boost CV, Float
Float Charging Voltage	13.5 V
High DC Input Recovery Voltage	14.5 V
High Frequency Disconnect	65 Hz
High Frequency Reconnect	63 Hz
High Line Disconnect Voltage	280 V
High Line Reconnect Voltage	270 V
Input Voltage Range	90-280 V
Input Voltage Range (UPS Mode)	170-280 V
Input Voltage Waveform	Sinusoidal (utility or generator)
Line Mode Output Waveform	Same As Input Waveform
Low DC Shutdown (<50% Load)	10.2 V
Low DC Shutdown (>50% Load)	9.6 V
Low Frequency Disconnect	40 Hz
Low Frequency Reconnect	42 Hz
Low Line Disconnect (Appliance Mode)	90 V
Low Line Disconnect (UPS Mode)	170 V
Low Line Reconnect (Appliance Mode)	100 V
Low Line Reconnect (UPS Mode)	180 V
Low-Battery Recovery (<50% Load)	11.2 V
Low-Battery Recovery (>50% Load)	10.6 V
MPPT Efficiency	99 %
MPPT Trackers	1
MPPT Voltage Range	30-90 V
Max AC Charge Current	120 A
Max AC Input Voltage	280 V
Max AC Pass-Through Current	25 A
Max Charging Current	120 A
Max Charging Voltage	15 V
Max Discharging Current	165 A
Max Efficiency	90 %
Max Inverter/Rectifier Current	15 A
Max PV Input Power	0.8 kW
Max PV Voltage	105 V
Max Solar Charging Current	60 A
Motor Start Capable	Yes
Nominal AC Input Voltage	230 V
Nominal DC Input Voltage	12 V
Nominal Input Frequency	50/60 Hz
Output Frequency	50/60 Hz
Output Short-Circuit Protection	Yes
Output Voltage Waveform	Pure Sine Wave
Overload Protection	Yes
Overload Trip Time (>105% Load)	10 s
Overload Trip Time (>150% Load)	5 s
Pass-Through Without Battery	Yes
Phase	Single Phase
Protection	Over Charge Protection, Overload Protection, Output Short Circuit Protection, Over Temperature Protection
Rated Apparent Output Power	2 kVA
Rated Output Power	2 kW
Short-Circuit Protection (Battery Mode)	Electronic Circuit
Start-Up Voltage	10.5 V
Strings per MPPT	1
Transfer Time (Appliance Mode)	20 ms
Transfer Time (UPS Mode)	4 ms

Mechanical

BMS Communication	RS485, CAN
Communication Interface	RS485, CAN
Display	LCD, LED
Gross Weight	8.2 kg
Installation Style	Wall-Mounted
Monitoring Module	Built-In WiFi
Net Weight	6.5 kg
Package Dimensions	438 x 358 x 202 mm
Parallel Capability	6
Topology	High-Frequency

Environmental

Cooling	Intelligent Air Cooling
IP Rating	IP21
Operating Temperature Range	-10 to 55 °C
Storage Temperature	-15 to 60 °C

Frequently Asked Questions

0.8 kW of PV, under a maximum PV voltage of 105 V and inside an MPPT operating window of 30-90 V. The single MPPT tracker runs at 99% efficiency and the unit's maximum efficiency is 90%.

12 V nominal, worked from 10.5 V to 15.75 V. Its one battery input takes AGM, flooded, Li-Ion or a self-defined profile; charging boosts at 14.1 V, floats at 13.5 V, never exceeds 15 V, and the unit starts up at 10.5 V.

90-280 V is the accepted AC input range, at 50/60 Hz, from a sinusoidal utility or generator supply; below 90 V the unit disconnects from the line. Transfer takes 20 ms and in line mode the output waveform follows the input.

2 Years. Net weight is 6.5 kg and gross weight 8.2 kg in a 438 x 358 x 202 mm package; the unit is wall-mounted, rated IP21 and runs from -10 to 55 °C.