What is the T2 error on Felicity?

T2 on a Felicity unit means: Akku lädt nicht voll.. It can appear on 1 device in the Felicity catalog. The cause and recommended fix are listed for each device on this page.

Can I clear the T2 code myself?

It depends on the severity. Warning-level codes can usually be cleared by following the recommended fix. Fault and critical codes often require checking the source condition first; if the code returns immediately after restart, escalate to authorized service.

Is the T2 fix the same on every device?

The cause is consistent — it's the same protection logic. The exact fix wording can differ per device because each official manual addresses model-specific context (input ranges, parallel-config notes, firmware revisions). Use the per-device section that matches your unit.

Where does this information come from?

Every entry is sourced directly from the official Felicity user manual for the affected device. The "Source" line at the bottom of each device's section shows the manual filename and page number.

Fault

T2

Akku lädt nicht voll.

1 Devices that report this code

What does the T2 error code mean?

T2 on a Felicity unit indicates: Akku lädt nicht voll.. It is a fault-severity event that can appear on 1 device in the Felicity catalog. The same code may have slightly different recommended fixes depending on the device — the per-device sections below show the exact wording from each device's official manual.

This is a fault-severity code

Fault codes stop normal operation but the unit may attempt to recover. Common causes are out-of-range conditions (voltage, current, temperature) that require checking inputs and outputs before restart.

What triggers this code

T2 is triggered when the unit's protection or monitoring logic detects the specific condition described above. The exact trigger depends on the device — see the per-device sections for the official manual entry for each.

FLS48100SG2Battery↗ view on device

T2Akku lädt nicht voll.Fault

Description

Battery does not fully charge. Maintenance troubleshooting item (no LCD code).

Cause

The charging voltage set on the inverter is too low (Ladespannung am Wechselrichter zu niedrig).

Recommended fix

Set the charging voltage on the inverter according to the recommended value in the battery manual (Max. charging voltage 57.6V; Float 57.6V; Cut-off 48V).

Source:Benutzerhandbuch - Felicity FLS48100SG2.pdf · page 27

Frequently asked about T2

What is the T2 error on Felicity?: T2 on a Felicity unit means: Akku lädt nicht voll.. It can appear on 1 device in the Felicity catalog. The cause and recommended fix are listed for each device on this page.
Can I clear the T2 code myself?: It depends on the severity. Warning-level codes can usually be cleared by following the recommended fix. Fault and critical codes often require checking the source condition first; if the code returns immediately after restart, escalate to authorized service.
Is the T2 fix the same on every device?: The cause is consistent — it's the same protection logic. The exact fix wording can differ per device because each official manual addresses model-specific context (input ranges, parallel-config notes, firmware revisions). Use the per-device section that matches your unit.
Where does this information come from?: Every entry is sourced directly from the official Felicity user manual for the affected device. The "Source" line at the bottom of each device's section shows the manual filename and page number.

Compiled from official Felicity user manuals. Always consult your device manual and a qualified technician before performing repairs.