Critical

F16

NO.2 Buckboost current sensor failed.

5 Devices that report this code

What does the F16 error code mean?

F16 on a Felicity unit indicates: NO.2 Buckboost current sensor failed.. It is a critical-severity event that can appear on 5 different devices in the Felicity catalog. The same code may have slightly different recommended fixes depending on the device — the per-device sections below show the exact wording from each device's official manual.

This is a critical-severity code

Critical codes trip the unit offline immediately. They typically indicate hardware failure (short-circuit, IGBT, BMS) or an unsafe operating condition. Do not bypass the fault — note the code and contact authorized service.

What triggers this code

F16 is triggered when the unit's protection or monitoring logic detects the specific condition described above. The exact trigger depends on the device — see the per-device sections for the official manual entry for each.

Apollo-5KLP1G01-MXEnergy storage system↗ view on device
F16NO.2 Buckboost current sensor failed.Critical
Description

Number 2 Buckboost current sensor failed.

Cause

NO.2 Buckboost current sensor failed.

Recommended fix

Restart the unit, if the error persists, contact the repair center.

Source:Apollo-5KLP1G01-All-in-one-ESS-User-Guide.pdf · page 43
IVEM 6048Inverter↗ view on device
F16Over current happen at PV port.Fault
Description

Fault: Over current happen at PV port.

Cause

Overcurrent at the PV input.

Recommended fix

Restart the unit, if the error persists, contact the repair center.

Source:felicitysolar IVEM 6048 Solar Inverter User Guide.pdf · page 37
IVEM8048-IIInverter↗ view on device
F16Over current happen at PV port.Fault
Description

Fault: Over current happen at PV port.

Cause

Over current detected at the PV input port.

Recommended fix

Restart the unit, if the error persists, contact the repair center.

Source:IVEM8K-12K-II_compressed.pdf · page 43
IVEM8048-LVInverter↗ view on device
F16Over current happen at PV port.Fault
Description

Over current happen at PV port.

Recommended fix

Restart the unit, if the error persists, contact the repair center.

Source:FelicitySolar IVEM8048-LV Single Phase Hybrid Inverter User Guide.pdf · page 38
T-REX-50KHP3G01Inverter↗ view on device
F16Battery 1 Overvoltage fault.Fault
Description

Battery 1 voltage is too high, the battery should be discharged.

Source:T-REX-50KHP3G01-user-manual-.pdf · page 46

Frequently asked about F16

What is the F16 error on Felicity?
F16 on a Felicity unit means: NO.2 Buckboost current sensor failed.. It can appear on 5 different devices in the Felicity catalog. The cause and recommended fix are listed for each device on this page.
Can I clear the F16 code myself?
It depends on the severity. Warning-level codes can usually be cleared by following the recommended fix. Fault and critical codes often require checking the source condition first; if the code returns immediately after restart, escalate to authorized service.
Is the F16 fix the same on every device?
The cause is consistent — it's the same protection logic. The exact fix wording can differ per device because each official manual addresses model-specific context (input ranges, parallel-config notes, firmware revisions). Use the per-device section that matches your unit.
Where does this information come from?
Every entry is sourced directly from the official Felicity user manual for the affected device. The "Source" line at the bottom of each device's section shows the manual filename and page number.

Compiled from official Felicity user manuals. Always consult your device manual and a qualified technician before performing repairs.