Warning

LED1 Flash (Power/Running Green LED ON, Red LED OFF)

Low SOC Warning.

1 Devices that report this code

What does the LED1 Flash (Power/Running Green LED ON, Red LED OFF) error code mean?

LED1 Flash (Power/Running Green LED ON, Red LED OFF) on a Felicity unit indicates: Low SOC Warning.. It is a warning-severity event that can appear on 1 device in the Felicity catalog. The same code may have slightly different recommended fixes depending on the device — the per-device sections below show the exact wording from each device's official manual.

This is a warning-level code

Warning codes do not stop the unit. They flag a condition that should be addressed before it escalates — usually a near-threshold reading or a configuration check.

What triggers this code

LED1 Flash (Power/Running Green LED ON, Red LED OFF) is triggered when the unit's protection or monitoring logic detects the specific condition described above. The exact trigger depends on the device — see the per-device sections for the official manual entry for each.

FLB48314TG1Battery↗ view on device
LED1 Flash (Power/Running Green LED ON, Red LED OFF)Low SOC Warning.Warning
Description

State of Charge below 10% (default threshold). LED1 flashes during Stand By, Normal, or Discharge modes.

Source:Felicity-FLB48314TG1-Manual.pdf

Frequently asked about LED1 Flash (Power/Running Green LED ON, Red LED OFF)

What is the LED1 Flash (Power/Running Green LED ON, Red LED OFF) error on Felicity?
LED1 Flash (Power/Running Green LED ON, Red LED OFF) on a Felicity unit means: Low SOC Warning.. It can appear on 1 device in the Felicity catalog. The cause and recommended fix are listed for each device on this page.
Can I clear the LED1 Flash (Power/Running Green LED ON, Red LED OFF) code myself?
It depends on the severity. Warning-level codes can usually be cleared by following the recommended fix. Fault and critical codes often require checking the source condition first; if the code returns immediately after restart, escalate to authorized service.
Is the LED1 Flash (Power/Running Green LED ON, Red LED OFF) fix the same on every device?
The cause is consistent — it's the same protection logic. The exact fix wording can differ per device because each official manual addresses model-specific context (input ranges, parallel-config notes, firmware revisions). Use the per-device section that matches your unit.
Where does this information come from?
Every entry is sourced directly from the official Felicity user manual for the affected device. The "Source" line at the bottom of each device's section shows the manual filename and page number.

Compiled from official Felicity user manuals. Always consult your device manual and a qualified technician before performing repairs.