Felicity MJS Solar Solutions

Felicity IVEM12048-11/IVEM4024-II/IVEM6048-II/IVEM8048-II

The Felicity IVEM12048-11 is an off-grid inverter with 12000VA rated output.

Models Covered: IVEM12048-11, IVEM4024-II, IVEM6048-II, IVEM8048-II

Manufacturer: Felicity Solar

Application: The Felicity IVEM12048-11 is an off-grid inverter with 12000VA rated output. Every figure on this page is taken from the manufacturer's datasheet for the IVEM12048-11.

Technical Specifications

Technical Specifications
Parameter IVEM12048-11IVEM4024-IIIVEM6048-IIIVEM8048-II
Electrical Characteristics
Nominal Input Voltage 230Vac230Vac Solar Charging & Grid Charging230Vac230Vac
Rated Output Power(W) 12000W4000W8000W
Nominal DC Input Voltage 48V24V48V
Additional Specifications
Max AC Input Voltage 280Vac
Pass Through Without Battery Yes
Rated Output Power(VA) 12000VA4000VA8000VA
Battery Over current happen at DCDC circuit DC/DC soft start fail. Over
RS232 +12V GND NC NC NC GND 0||||||0 Ollo
High Line Voltage Disconnect 280Vac±7V
Low Line Voltage Disconnect 170Vac±7V (UPS); 90Vac±7V (Appliances)
Output voltage OP 0 230 Default: 60A 240V OP 01 240 Default: 30A OPF 02 50 CHC 07
Battery Type If inverter doesn't connect battery or
Battery Type Setting 29.2V
Cut-off Voltage program 9, 10 and 11.
Float Voltage 54~65
High DC Input Recovery 30V±0.4V Unpacking and Inspection General Specifications
High Line Frequency Disconnect 65±1Hz
Input Voltage 28¬
Input Voltage Range 90~280Vac (For Home Appliances) ; 180~280Vac (For Computers) 4000VA90~280Vac
Low DC Input Shut-down Load < 50% 21.0V least 5 minutes before wiring and checking.
Low Line Frequency Disconnect 40±1Hz
Max. Bypass Overload Current 30A
Max. Charge Current 120A100A 120A
Max. Charging Current(PV+Grid) 120A
Max. Input Current 27A
Max. Inverter/Rectifier Current 30A/4000W
Min. Startup Voltage 60V
Nominal Input Frequency 50Hz/60Hz (
Output frequency configuration 60Hz OPF 02 60 AC 03 APL AC 03 UPS Default: 27.0V bAt 08 66º 13 270 bAt 08 program 4
Overcharge Protection Yes
Over-Load Protection (SMPS load) Load>200%,200ms / Load >150%,5.5s Load >120%, 7.5s / Load >105% 10.5s A
PV Array MPPT Voltage Range 60Vdc 430Vdc
Parallel Capability NoYes, Up to 12 Units
Power point in program 12. CHS 0S SAU together. OP 02201
RS485 PIN 7 NC PIN 8 NC Lithium
Surge Rating 2*
Cold Start Voltage 23V
Output 90V 170V 280V Input Voltage Battery Type Setting Flooded 29.2V 27V
Output Short-Circuit Protection Yes
Over-Load Protection there is no strong electromagnetic interference Ensure installation site. the around devices electrical or caused by other electronic SMPS load
Installation IVEM4024-II Safety Guidance 4000VA
Grid / AC Frequency 50Hz/60Hz (Auto detection)
Start-up Voltage 95V
Capable of Starting Electric Motor Yes
Dimensions (W×H×D) 420*335*142MM
Package Dimensions 512*417*216MM
AC Output
Nominal Output Voltage 230Vac+5% installation and operation of inverter must be carried out by The professional technicians who have received professional trainings and thoroughly familiar with
Rated Output Power 4000VA Nominal Output Voltage Dependent on battery type; 4000W Max. Charge Current 120A
Nominal Output Frequency 50±0.3Hz/60Hz±0.3Hz (Adjustable)
Output Voltage Waveform Pure sine wave
AC Output Voltage 230Vac±5%
Output Frequency 50±0.3Hz/60Hz±0.3Hz(Adjustable)
Efficiency
Peak Efficiency 93% inverter are disconnected and wait for at least 5 minutes.
Efficiency(Line Mode) > 93% (Rated R load, battery full charged)>95% (Rated R Load, Batte Full Charged)
Max Efficiency 93%
PV Input
Max PV Open-Circuit Voltage 500V
PV Voltage Working Range 60V-500V
Max. Input Power 6000W
Max. Solar Charging Current 120A
Max PV Input Power 7000W 7500W
Battery Charging
Battery Charging Current Up to 120A
Charge Current Regulation 10-120A (Adjustable unit is 1A)
Mechanical Data
Gross Weight 11.9KG
Product Size (D*W*H) 430x310x120mm
Package Dimension (D*W*H) 507x387x197mm
Net Weight 11.5KG 12.5KG
Operating Conditions
Operating Temperature -10C°~50C°-10°C~50°C
Range Storage Temperature -15C°~60C°
PV String Input Data
Nominal DC Voltage 48V

Figures are measured at the test conditions the manufacturer’s datasheet states. A dash means the manufacturer publishes no figure for that model.

Availability & grid compliance in Sudan

Market Sudan
Grid authority / regulator Sudanese Electricity Distribution Company (SEDC), Ministry of Energy and Petroleum
Quotation currency SDG
Support hours timezone Africa/Khartoum
Delivery & installation coverage Khartoum, Omdurman, Port Sudan, Kassala, Nyala

Figures on this page are the manufacturer's own, measured at the test conditions the datasheet states — they do not change by country. What changes is the approval that has to be met before the unit is energised: in Sudan that is Sudanese Electricity Distribution Company (SEDC), Ministry of Energy and Petroleum. Confirm the grid code, import requirements and any local certification with them, or with us, before you order.

Key Features & Technical Highlights

  • Wide PV voltage input: range (60VDC-500VDC)
  • Battery charging power up: to 120A
  • Built-in MPPT solar charge: controller
  • Configurable battery charging current: based on applications via LCD setting
  • Auto restart while AC: is recovering
  • Inverter running without battery: Inverter running without battery

Frequently Asked Questions

What are the main performance specifications of the IVEM4024-II inverter?

The IVEM4024-II inverter has a rated output power of 4000VA and operates with a nominal output voltage of 230Vac. It offers a peak efficiency of 93% and can handle a maximum input power of 6000W.

Is the IVEM4024-II inverter compatible with different solar panel systems?

Yes, the IVEM4024-II inverter is compatible with solar panel systems that have a PV voltage working range of 60V to 500V, making it versatile for various setups.

What are the physical specifications of the IVEM4024-II inverter?

The IVEM4024-II inverter has a net weight of 10.4 kg. Please refer to the product manual for detailed dimensions and IP rating information.

What are the installation requirements for the IVEM4024-II inverter?

The IVEM4024-II inverter should be installed in a location with an operating temperature range of -10°C to 50°C. Ensure proper ventilation and follow the installation guidelines provided in the manual.