Felicity IVEM12048-11/IVEM4024-II/IVEM6048-II/IVEM8048-II
The Felicity IVEM12048-11 is an off-grid inverter with 12000VA rated output.
Technical Specifications
| Parameter | IVEM12048-11 | IVEM4024-II | IVEM6048-II | IVEM8048-II |
|---|---|---|---|---|
| Electrical Characteristics | ||||
| Nominal Input Voltage | 230Vac | 230Vac Solar Charging & Grid Charging | 230Vac | 230Vac |
| Rated Output Power(W) | 12000W | 4000W | — | 8000W |
| Nominal DC Input Voltage | 48V | 24V | — | 48V |
| Additional Specifications | ||||
| Max AC Input Voltage | 280Vac | |||
| Pass Through Without Battery | Yes | |||
| Rated Output Power(VA) | 12000VA | 4000VA | — | 8000VA |
| Battery | Over current happen at DCDC circuit DC/DC soft start fail. Over | |||
| RS232 | +12V GND NC NC NC GND 0||||||0 Ollo | |||
| High Line Voltage Disconnect | 280Vac±7V | |||
| Low Line Voltage Disconnect | 170Vac±7V (UPS); 90Vac±7V (Appliances) | |||
| Output voltage | OP 0 230 Default: 60A 240V OP 01 240 Default: 30A OPF 02 50 CHC 07 | |||
| Battery Type | If inverter doesn't connect battery or | |||
| Battery Type Setting | 29.2V | |||
| Cut-off Voltage | program 9, 10 and 11. | |||
| Float Voltage | 54~65 | |||
| High DC Input Recovery | 30V±0.4V Unpacking and Inspection General Specifications | |||
| High Line Frequency Disconnect | 65±1Hz | |||
| Input Voltage | 28¬ | |||
| Input Voltage Range | — | 90~280Vac (For Home Appliances) ; 180~280Vac (For Computers) 4000VA | 90~280Vac | — |
| Low DC Input Shut-down | Load < 50% 21.0V least 5 minutes before wiring and checking. | |||
| Low Line Frequency Disconnect | 40±1Hz | |||
| Max. Bypass Overload Current | 30A | |||
| Max. Charge Current | — | 120A | 100A 120A | — |
| Max. Charging Current(PV+Grid) | 120A | |||
| Max. Input Current | 27A | |||
| Max. Inverter/Rectifier Current | 30A/4000W | |||
| Min. Startup Voltage | 60V | |||
| Nominal Input Frequency | 50Hz/60Hz ( | |||
| Output frequency configuration | 60Hz OPF 02 60 AC 03 APL AC 03 UPS Default: 27.0V bAt 08 66º 13 270 bAt 08 program 4 | |||
| Overcharge Protection | Yes | |||
| Over-Load Protection (SMPS load) | Load>200%,200ms / Load >150%,5.5s Load >120%, 7.5s / Load >105% 10.5s A | |||
| PV Array MPPT Voltage Range | 60Vdc 430Vdc | |||
| Parallel Capability | — | No | Yes, Up to 12 Units | — |
| Power | point in program 12. CHS 0S SAU together. OP 02201 | |||
| RS485 | PIN 7 NC PIN 8 NC Lithium | |||
| Surge Rating | 2* | |||
| Cold Start Voltage | 23V | |||
| Output | 90V 170V 280V Input Voltage Battery Type Setting Flooded 29.2V 27V | |||
| Output Short-Circuit Protection | Yes | |||
| Over-Load Protection | there is no strong electromagnetic interference Ensure installation site. the around devices electrical or caused by other electronic SMPS load | |||
| Installation | IVEM4024-II Safety Guidance 4000VA | |||
| Grid / AC Frequency | 50Hz/60Hz (Auto detection) | |||
| Start-up Voltage | 95V | |||
| Capable of Starting Electric Motor | Yes | |||
| Dimensions (W×H×D) | 420*335*142MM | |||
| Package Dimensions | 512*417*216MM | |||
| AC Output | ||||
| Nominal Output Voltage | 230Vac+5% installation and operation of inverter must be carried out by The professional technicians who have received professional trainings and thoroughly familiar with | |||
| Rated Output Power | 4000VA Nominal Output Voltage Dependent on battery type; 4000W Max. Charge Current 120A | |||
| Nominal Output Frequency | 50±0.3Hz/60Hz±0.3Hz (Adjustable) | |||
| Output Voltage Waveform | Pure sine wave | |||
| AC Output Voltage | 230Vac±5% | |||
| Output Frequency | 50±0.3Hz/60Hz±0.3Hz(Adjustable) | |||
| Efficiency | ||||
| Peak Efficiency | 93% inverter are disconnected and wait for at least 5 minutes. | |||
| Efficiency(Line Mode) | — | > 93% (Rated R load, battery full charged) | >95% (Rated R Load, Batte Full Charged) | — |
| Max Efficiency | 93% | |||
| PV Input | ||||
| Max PV Open-Circuit Voltage | 500V | |||
| PV Voltage Working Range | 60V-500V | |||
| Max. Input Power | 6000W | |||
| Max. Solar Charging Current | 120A | |||
| Max PV Input Power | 7000W 7500W | |||
| Battery Charging | ||||
| Battery Charging Current | Up to 120A | |||
| Charge Current Regulation | 10-120A (Adjustable unit is 1A) | |||
| Mechanical Data | ||||
| Gross Weight | 11.9KG | |||
| Product Size (D*W*H) | 430x310x120mm | |||
| Package Dimension (D*W*H) | 507x387x197mm | |||
| Net Weight | 11.5KG 12.5KG | |||
| Operating Conditions | ||||
| Operating Temperature | — | -10C°~50C° | -10°C~50°C | — |
| Range Storage Temperature | -15C°~60C° | |||
| PV String Input Data | ||||
| Nominal DC Voltage | 48V | |||
Figures are measured at the test conditions the manufacturer’s datasheet states. A dash means the manufacturer publishes no figure for that model.
Availability & grid compliance in Kuwait
| Market | Kuwait |
| Grid authority / regulator | MEW Kuwait |
| Quotation currency | KWD |
| Support hours timezone | Asia/Kuwait |
| Delivery & installation coverage | Kuwait City, Hawalli, Salmiya |
Figures on this page are the manufacturer's own, measured at the test conditions the datasheet states — they do not change by country. What changes is the approval that has to be met before the unit is energised: in Kuwait that is MEW Kuwait. Confirm the grid code, import requirements and any local certification with them, or with us, before you order.
Key Features & Technical Highlights
- Wide PV voltage input: range (60VDC-500VDC)
- Battery charging power up: to 120A
- Built-in MPPT solar charge: controller
- Configurable battery charging current: based on applications via LCD setting
- Auto restart while AC: is recovering
- Inverter running without battery: Inverter running without battery
Frequently Asked Questions
What are the main performance specifications of the IVEM4024-II inverter?
The IVEM4024-II inverter has a rated output power of 4000VA and operates with a nominal output voltage of 230Vac. It offers a peak efficiency of 93% and can handle a maximum input power of 6000W.
Is the IVEM4024-II inverter compatible with different solar panel systems?
Yes, the IVEM4024-II inverter is compatible with solar panel systems that have a PV voltage working range of 60V to 500V, making it versatile for various setups.
What are the physical specifications of the IVEM4024-II inverter?
The IVEM4024-II inverter has a net weight of 10.4 kg. Please refer to the product manual for detailed dimensions and IP rating information.
What are the installation requirements for the IVEM4024-II inverter?
The IVEM4024-II inverter should be installed in a location with an operating temperature range of -10°C to 50°C. Ensure proper ventilation and follow the installation guidelines provided in the manual.