Défaut

FAULT: LED1=ON, LED2=OFF, LED3=OFF, LED4=OFF (Green OFF, Red ON)

Battery Voltage High (Fault).

2 Appareils signalant ce code
LPBF24200-MBatterie↗ voir sur l’appareil
FAULT: LED1=ON, LED2=OFF, LED3=OFF, LED4=OFF (Green OFF, Red ON)Battery Voltage High (Fault).Défaut
Description

Pack over-voltage protection has tripped; output is disabled.

Cause

Pack voltage exceeded the BMS over-voltage protection threshold during charging.

Correction recommandée

Disconnect the charging source, verify charge-voltage settings, and allow the pack voltage to fall before re-enabling output.

Source:Felicitysolar LPBF24200-M LiFePO4 Battery System for Households User Guide.pdf · page 9
LPBF48250Batterie↗ voir sur l’appareil
FAULT: LED1=ON, LED2=OFF, LED3=OFF, LED4=OFF (Green OFF, Red ON)Battery Voltage High.Défaut
Description

Pack-level over-voltage protection has tripped; output is disabled. Listed in the FAULT row of the LED table on page 7 as 'BATTERY VOLTAGE HIGH'.

Cause

Pack voltage exceeded the BMS over-voltage threshold during charging — e.g. charger output above the recommended Max. Charging Voltage of 57.6 V (section 2.4).

Correction recommandée

Stop charging, verify the charger / inverter Max. Charging Voltage and Floating Charging Voltage are set to 57.6 V per section 2.4, and allow the pack voltage to fall back into the 48-57.6 V range before re-enabling output.

Source:Battery Manual LPBF48250 (EN).pdf · page 7

Compilé à partir des manuels utilisateur officiels FelicityESS. Consultez toujours le manuel de votre appareil et un technicien qualifié avant toute réparation.